I am currently a PhD student in hydrology at Strasbourg University in France. I found mSim to be an awesome way to generate meshes and I am extremely thankful about you posting your tutorials on this website. I will quote you as required.
However, I have to tell you about a bug I have encountered.
When “usertol” is chosen big enough to smooth the initial polygon from “domain.shp”, the line loop defining the domain becomes wrong.
While I should get “Line Loop(1) = 1,2,3,4,5,6….” I get instead “Line Loop(1) = {1,1,1,1,1,1,2,2,2,3,3,3,3,4,5,5,5,6,6,7”.
It only happen when usertol is big enough to smooth a reasonable amount of points on the edge (in my example with usertol=1m, everything is fine, but with usertol =10 i get this error).
In any case, thanks for your awesome routines and website.
Best regards,
Benjamin Jeannot.
Hello Georges Kourakos,
I am currently a PhD student in hydrology at Strasbourg University in France. I found mSim to be an awesome way to generate meshes and I am extremely thankful about you posting your tutorials on this website. I will quote you as required.
However, I have to tell you about a bug I have encountered.
When “usertol” is chosen big enough to smooth the initial polygon from “domain.shp”, the line loop defining the domain becomes wrong.
While I should get “Line Loop(1) = 1,2,3,4,5,6….” I get instead “Line Loop(1) = {1,1,1,1,1,1,2,2,2,3,3,3,3,4,5,5,5,6,6,7”.
It only happen when usertol is big enough to smooth a reasonable amount of points on the edge (in my example with usertol=1m, everything is fine, but with usertol =10 i get this error).
In any case, thanks for your awesome routines and website.
Best regards,
Benjamin Jeannot.
Thank you for you comments.
I’ll look into this issue shortly.
Best